Samsung Jet Stick brush stops spinning

Overheating can damage your vacuum. So if it starts to potentially reach a condition where it might overheat, it will shut off instead. Check for a few potential problems and let your vacuum cool down in order to use it again.

If your microwave is not turning on, or if it is turning off by itself, it could have overheated. When a microwave has been in use for a long time and overheats, just give it 30 minutes to cool off and then try to use it again. Otherwise, you'll need to check the light, the outlet, and the power cord.

If your dryer is heating but the clothes are still damp, then your vent is probably blocked. If your dryer has weak heat and runs for a long time, this could also indicate a blocked vent. And if your dryer ends after only a couple of minutes with soaking wet clothes, then your moisture sensors could be dirty. To make sure you're performing the corr

Run diagnostics on a front load washer Important: The purpose of Smart Install is to check for an error code. If the washer is already displaying an error code, do not perform Smart Install. To perform Smart Install: 1. Make sure the washer is empty and turn the washer on. 2. Set the washer to Delay End for 17 hours. Important: If the washer has be

Run a Vent Blockage test Note: Even if your dryer passes the test, you should still clean your exhaust vent once or twice a year. If you used your dryer prior to starting the test, it may not enter the test mode; your dryer must be sufficiently cooled down first. If you’re running the test right after installing your dryer, you can run the AIR FLUF